XRAY XB2C 22' Edition Build

Děkujeme! Podělte se svými přáteli!

Nelíbí sa vám video. Děkujeme za zpětnou vazbu!

Vloženo před 2 roky by admin

124 Zobrazení

Follow along as I build the XRAY XB2C 22' Edition.

How to prep/clean your RC Bearings - https://www.youtube.com/watch?v=LbAZJgXhCYE

Install the wing mount last as it can get in the way of some other pieces that you need to install. Fitment of the transmission halves is not that great from bag 2, but I found that the gaps tended to close up during the installation of bag 3. Be patient and check to make sure your transmission is moving freely after each time you screw into the transmission. I didn’t install the turnbuckles the way the manual intended. I installed them like the industry standard I’ve seen with the left-hand threads on the left side of the car. This allows for adjustment in the same direction on both sides of the vehicle.

Check out Houston RC at https://houstonrc.net/
They don't have an online shop, but you can message them here to order HoustonRCRacers@Gmail.com

MIP Driver Set - https://amzn.to/3FhjpFP
snips, diagonal cutters https://amzn.to/3wLhM1d
x-acto blades https://amzn.to/3Ni7ZWe
Lubricant for RC Bearings - https://amzn.to/36SwyIC
Nevr Dull - https://amzn.to/3JoBVNd
Tool Kit - https://amzn.to/371mAo7
Electric Screwdriver – https://amzn.to/3ICdWd1
Hex Bits - https://amzn.to/3IIl2g8
Lipo Batteries - https://amzn.to/3umRMGw
Lipo Bag - https://amzn.to/3qyRR8R
EBL Battery Charger - https://amzn.to/3ID2duq
EBL Rechargeable Batteries - https://amzn.to/3IDq65f

ride height suggestion 13/14, 14/14, 14/15mm - link to 3d print https://www.thingiverse.com/thing:5327466
Buggy Stand with shock building holes: https://www.thingiverse.com/thing:5274707