Volantex Ranger 2000 FPV RC Plane Build Part 3 - Install EZUHF Long Range Receiver & Antenna

Děkujeme! Podělte se svými přáteli!

Nelíbí sa vám video. Děkujeme za zpětnou vazbu!

Vloženo před 6 roky by

357 Zobrazení

Volantex Ranger 2000 FPV RC Plane Build Part 3 - Install EZUHF Long Range Receiver & Antenna
https://youtu.be/GG4qDnr3FdQ

Blog: All the changes to the FPV system will be in one place
https://davemerc.blogspot.com/

Setup EZUHF LQ or RSSI on MinimOSD for APM
https://www.youtube.com/watch?v=rh7-D96FIK0

EZUHF NANO RX Updating Firmware and Binding to JR TX Module and EZUHF TX Can
https://www.youtube.com/watch?v=-lWwu6KTp8Y

This FPV Build Part 3 is the installation of the EZUHF Long Range Receiver and antenna in the tail section.

The Ranger 2000 is an easy to assemble FPV pusher glider and features a large wingspan for stability in the air. The wings are fitted with two spars to strengthen the wings and they are attached using fast connecting wing clips to join the wings into the fuselage. After flying, simply squeeze the clips to release the wings and easily store the plane in your car.

The fuselage has the capacity for an FPV camera and related components. The plug-and-fly plane is a single-body aircraft with a plastic fuselage that offers flexible, lightweight protection in case of crash landings. At the front of the fuselage, a pre-cut hole gives you the option of adding an FPV camera. The position puts you right in the pilot's seat without having to cut into the sturdy body of the plane yourself. Remove the black canopy to reveal a flat bed for mounting different cameras, transforming your glider into the perfect FPV model or videography vehicle.