The Problem with Low Voltage Cutoffs for Very High Performance RC's

Děkujeme! Podělte se svými přáteli!

Nelíbí sa vám video. Děkujeme za zpětnou vazbu!

Vloženo před 3 roky by

161 Zobrazení

Set your Voltage Cutoff so that you get good performance and safe LiPo packs!

Mystery Line on the Whiteboard:
NiMh batteries can be plugged in to an ESC that is setup for LiPo's. However, if you were to plug a 6 cell NiMh pack in, the ESC would recognize it as a 2s LiPo. The typical performance range of a NiMh pack may have majority of it's peformance occur below the Low Voltage Cutoff (LVC) of the LiPo pack. This will cause your NiMh pack to have a very short run time. If using batteries of a different chemistry, check to make certain your LVC is OK.

???? Have a question about RC? Consider supporting the channel and send me a message through Patreon chat: ????
Patreon Page: https://www.patreon.com/rcexplained

????️ Ordering from Amazon? Use this Affiliate Link to support the channel: ????️
https://amzn.to/2QTNjHL

Kv vs Torque (Lower Kv motors, don't produce more torque)
https://youtu.be/qkSPjNmxcl4

How to Avoid the Biggest RC Motor Mistake.
https://youtu.be/d7VwNPKKyXk

Does Increasing the Motor Kv value Increase an RC Cars Top Speed?
https://youtu.be/A07tY8VFlcM

#RCexplained