I covered a 3D printed plane with iron on covering and it didn’t melt!

Děkujeme! Podělte se svými přáteli!

Nelíbí sa vám video. Děkujeme za zpětnou vazbu!

Vloženo před 2 roky by

78 Zobrazení

I'm experimenting with the design of a 48" wingspan Pitts 3D printed biplane. This is not the typical single wall 3d print but rather a very strong and light "stick" type build. This video shows Ultracote covering on the horizontal stabilizer that was 3D printed in PETG.