How to quickly and EASILY tune a nitro rc engine in 30min!!!

Děkujeme! Podělte se svými přáteli!

Nelíbí sa vám video. Děkujeme za zpětnou vazbu!

Vloženo před 2 roky by admin

124 Zobrazení

Hey guys!

Thanks for taking the time to get this far!
I've had this nitro for little over a month and wanted to learn how to easily tune a nitro engine from scratch.

So I defaulted my high speed needle and low speed needle flush with the housings and went at it.

I completed the full tune of this nitro engine in under 30min!! It's that easy. Sure it's not a race tune or one that will win me speed records, but it's good enough for the backyard basher or the leisure nitro owner.

Here are the steps to complete this procedure:

1. Check and adjust the idle gap to between 0.5mm and 1mm.
2. Change your high speed needle flush with the brass housing.
3. Change your low speed needle flush with the slide
4. Go out and run the vehicle. First tune the high speed needle and lean it out for the best top speed until it bogs. Then richen it a tad.
5. Lean out the low speed needle to get those crisp and snappy take offs.

And that is it! I hope this little procedure helps you to get a decent tune on your nitro engine to enjoy it!

Cheers!