How to Build Twin Motor Douglas DC-3 RC Plane Part 1

Děkujeme! Podělte se svými přáteli!

Nelíbí sa vám video. Děkujeme za zpětnou vazbu!

Vloženo před 4 roky by

237 Zobrazení

About 2 months ago I held a polling on my community tab, to decide between Douglas DC-3
or DHC-6 Twin Otter, the winner for the next twin motor RC model plane is Douglas DC-3. This project should have began last week but I ran out of 3mm foam board. I mainly use
3mm depron foam or polyfoam for the material and 5mm for the formers. The wingspan will
be 2200 mm or 87 inches. This project will be devided into 3 or 4 parts, from start to finish
and fly. In between each part I will make 2 new projects, so it will not too boring on just 1
subject.

SUBSCRIBE and Like to support this channel
#dc3 #rcplane #buildvideo

Playlist :
01:09 Plans Preparation
02:04 Nose Section
08:31 Fuselage
12:54 Vertical Stabilizer
16:17 Next Project?

You can download the plans on the link below :
http://paper-replika.com/index.php?option=com_content&view=article&id=9624:douglas-dc-3-rc-plane-part-1&catid=144:rc-projects&Itemid=207908

Specs :
1. Wingspan 2200mm / 87 inches
2. Flying weight : -
3. Wing loading : -
4. Wing cube loading : -
5. Wing Area : 25.2 dm2 / 391 sq.in
6. CG : -

Electronics
- 2X Turnigy 2830 1000kv brushless motor
- ESC 40A
- Battery Lipo 3S 2200mah - Li-ion 3S 3300 mah
- 4 plastic gear 9 gram servos
- 5 metal gear 9 gram servos
- Propeller : 9x6x3

Materials :
1. 5mm & 10mm Depron/ Polyfoam
2. 3mm Plywood
4. 0.3mm Mica Plastic
5. hot glue + CA glue + UHU glue
6. wax paper