E flite UMX mig 15 edf Jet test flight crashes maiden #1 with a emitting wing servo?

Děkujeme! Podělte se svými přáteli!

Nelíbí sa vám video. Děkujeme za zpětnou vazbu!

Vloženo před 5 roky by

243 Zobrazení

pickup this jet up off ebay, from a seller that re sell horizon hobby returns, said defective on the box the left wing servo not working, buy as is. i also bought a new servo, 4 batteries , and a charging cable for this jet. i remove the cockpit and found servo connector had a short in it, got it working and didn't put new servo in wing yet. in this test flight the servo was emitting doing some weird stuff in flight, not sure if it a bad servo or something wrong with the RX AS3X board , today i flew 2 batteries in it. with about 4 crashes, two which went in the trees LOL ,kept edf fan power on and it came down both times. lucky i guess. it took some hard hits on the nose, i've will hot water the foam, might put new servo in , and or put a Y connector on ailerons, but not buying a new as3x board for it. if i cant make it fly again i will use it for parts jet, buy another one it FLY GREAT (13,500Kv motor is very fast ) while the servo left wing not acting up. i bought this jet cheap. hoping this jet fly again , love the way it goes, no trimming was needed. i will add three videos from these flight today.

https://www.horizonhobby.com/umx-mig-15-edf-bnf-basic-w-as3x-and-safe-select-p-eflu6050

What's in the Box?
(1) UMX MiG-15 EDF Jet Plane
(1) BL180m Ducted Fan Motor, 13,500Kv (installed)
(1) Delta-V 180m 28mm EDF Unit (installed)
(1) Spektrum DSMX® 6Ch AS3X® Receiver with Brushless ESC (installed)
(2) 2.3-Gram Performance Linear Long Throw Servos (installed)
(2) 2.3-Gram Linear Long Throw Offset Servos (installed)
(1) Product Manual

video camera : runcam2 in 1080p 60fps
editor : videopad professional editor by NCH

THANKS FOR WATCHING, LIKE, COMMENT, SUBSCRIBE, AND HIT THE BELL
BOAR OVER BROOK RC : pilot rhuffines13 (aka) Randy

thnxs for watching, comment, like, sub, and hit the Bell !
i do all this for fun, and try to help others grow in rc community, if you sub i sub that the way it is. Randy