In this video, James shows you some tips and steps for customizing the base gray F-18C from Freewing, but could also work for any foam model. Don't be afraid to customize! Links for everything below:
Base Gray F-18C: https://www.motionrc.com/collections/jets-and-ducted-fan/products/freewing-f-a-18c-hornet-base-gray-90mm-edf-jet-pnp
HobbySquawk Thread: https://www.hobbysquawk.com/forum/rc-airplanes/military-jets/186270-official-freewing-f-a-18c-hornet-90mm-edf-thread/page45
3D Printed Parts:
Sidewinders (printed at 100%) from DirtyDee: https://www.thingiverse.com/thing:2747018
GBU-12's (Printed at 85%) from DirtyDee: https://www.thingiverse.com/thing:2991798
Litening Lazer Targeting Pod (printed at 70%) from DirtyDee (cost $5): https://cults3d.com/en/3d-model/game...-targeting-pod
Fuel Tanks (actually Napalm Canisters) (printed at 125%) by APmech1: https://www.thingiverse.com/thing:2859866
Pylons for under the wings (x4) (printed at 100%) by bettsmums: https://www.thingiverse.com/thing:3229496
Center Pylon (printed at 70%) by bettsmums: https://www.thingiverse.com/thing:3117452
Then for the wing pylons I used 2 packs of Freewing F-16 rails that we sell here: https://www.motionrc.com/products/fr...hment-hardware
But you could also print these and they work. (I printed these at 70%) for the center pylon from APmech1: https://www.thingiverse.com/thing:2858226
Base Gray F-18C: https://www.motionrc.com/collections/jets-and-ducted-fan/products/freewing-f-a-18c-hornet-base-gray-90mm-edf-jet-pnp
HobbySquawk Thread: https://www.hobbysquawk.com/forum/rc-airplanes/military-jets/186270-official-freewing-f-a-18c-hornet-90mm-edf-thread/page45
3D Printed Parts:
Sidewinders (printed at 100%) from DirtyDee: https://www.thingiverse.com/thing:2747018
GBU-12's (Printed at 85%) from DirtyDee: https://www.thingiverse.com/thing:2991798
Litening Lazer Targeting Pod (printed at 70%) from DirtyDee (cost $5): https://cults3d.com/en/3d-model/game...-targeting-pod
Fuel Tanks (actually Napalm Canisters) (printed at 125%) by APmech1: https://www.thingiverse.com/thing:2859866
Pylons for under the wings (x4) (printed at 100%) by bettsmums: https://www.thingiverse.com/thing:3229496
Center Pylon (printed at 70%) by bettsmums: https://www.thingiverse.com/thing:3117452
Then for the wing pylons I used 2 packs of Freewing F-16 rails that we sell here: https://www.motionrc.com/products/fr...hment-hardware
But you could also print these and they work. (I printed these at 70%) for the center pylon from APmech1: https://www.thingiverse.com/thing:2858226
- Kategorie
- RC Stíhačky
Komentáře