Building & flying an RC plane with 3D Printed parts

Děkujeme! Podělte se svými přáteli!

Nelíbí sa vám video. Děkujeme za zpětnou vazbu!

Vloženo před 4 roky by

187 Zobrazení

This was my first attempt at 3d-printing structural components for an RC plane to make assembly and disassembly less time-consuming for easier transport to and from the flying field.

--- Components Used: ---
- Motor: EMAX 2205 2300kv brushless motor
- ESC: 30A Hobbywing w/ motor braking enabled
- Prop: 6045 Bullnose
- tX: Spektrum dX6, rX: Orangerx 6ch
- Tattu 3s 900 mAh lipo
- 4x MG90 9g servos
- 0.75m carbon fiber tube, 12mm OD

Onboard video footage was shot from a Runcam Hybrid mounted on the tail. All other footage was shot from my iPhone 7.

All printed parts were printed using PLA on my Tevo Tornado, 0.08mm layer height, 3 perimeters, 20% gyroid infill.

Music by https://soundcloud.com/lakeyinspired