1/8 HobbyKing BSR Berserker Wing Mount Install and Thoughts

Děkujeme! Podělte se svými přáteli!

Nelíbí sa vám video. Děkujeme za zpětnou vazbu!

Vloženo před 6 roky by admin

270 Zobrazení

Broke the wing mount clean off of the Berserker during its last run and as I'm replacing the broken pieces I started realizing that the plastic that they used may not be the culprit.

The mounts do not bolt on straight and the middle of the wing mounts are pinched against the inside of the aluminum tower which put them under a constant stress once all the pieces are tightened down. Looks like the solution may be grinding down the mounting points towards the center of the buggy down a few mm which should alleviate the stress.

Setup:
T-Bone Racing Bastion Front Bumper for Arrma Typhon
DE Racing XD Rear Skid Plate (DER-210-M)
Losi Standard 1/8 Truggy Dish Wheels
JConcepts Double Dee's Truggy Tires Soft (Blue Compound)
BSR Berserker Wheelie Bar
BSR Berserker Shock Shaft Covers
Underbody sprayed w/ Rust-Oleum Truck Bed Coating
Spektrum DX3C Tx w/ OrangeRX GR300 Rx

Upcoming Mods:
Trackstar 50K Diff Fluid Front and Rear
RPM Mud Guards
Louise T-Pirate Truggy Super Soft Tires on 1/2" Offset White Dish Wheels

Camera Used:
Sony HDR-AS100V/R Action Cam