1/10 Scale Horten IX Ho-229 3D Printed RC Jet - XRP Fans

Děkujeme! Podělte se svými přáteli!

Nelíbí sa vám video. Děkujeme za zpětnou vazbu!

Vloženo před 2 roky by

93 Zobrazení

Flight #8 on the Horten. I re-installed a longer nose spring so the T-33Nose strut had its full length. This helped the plane take-off drastically shorter than before. 150 ft now compared to the previous 350 ft when the nose was shortened.

A bit of a boring flight, but I was testing using the 50mm XRP fans with 4200kV motors. The original QX fans seem better as the XRPs dont give the same top end speed. I will be re-installing the QX fans.

STLs will be made available later this summer.

Download will be shared on Cults3D:
https://cults3d.com/en/users/DirtyDee/creations